3D printed pieces for Scathach and Cu's Gae Bolg lances.

Made to go on 3/4" PVC pipe, but can also be used with a 1" dowel with a tiny bit of room to spare. Blades assemble on 1/4" dowels for strength.

CU Kit Includes:
- 1x Blade Base
- 1x Blade Top
- 1x Bottom Shaft Lower
- 1x Bottom Shaft Upper
- 1x Bottom Spike
- 1x Top Shaft

SCATHACH Kit Includes:
- 1x Blade Base
- 1x Blade Middle
- 1x Blade Tip
- 1x Bottom Lower
- 1x Bottom Upper
- 1x Fronds
- 1x Spike
- 1x Top Upper
- 1x Top Lower

While I do print at a higher quality than most printers, as with any 3D print, pieces still require some sanding and filling to remove the tiny print lines. Usually 1-2 coats of filler primer and sanding with 150 and 320 sandpaper is enough to put them in a paintable condition.

Shipping time subject to available printer time. It takes about 2 days to print a set; please allow up to 1-2 weeks for production. Filament will generally be red but if we're out, you may get silver or black.