3D models for Link and Revali's Great Eagle Bow. Files are emailed within 24 hours to address on invoice.

.stl format. Pre-sliced for printing on a 20cmx20cmx20cm bed with some pieces for 20cmx20x30cm, with internal keys and dowel channels for strength and alignment. Dowel channel for center of bow takes a square dowel so the arm does not rotate; this way you can disassemble the bow for travel.

Files include:
- Photos
- .STL files

Bow uses three 5.5" and one 11" dowel (1/2" diameter) for the shafts, and a 1/2" square dowel for the center.

We printed ours at 0.1 and 0.15mm layers. We suggest keeping a moderate infill (no lower than 15%) and walls of about 1-1.2mm.

Please do not redistribute or resell. Intended for personal use only. Commercial use must buy a new copy for each item produced.

Model by Jennifer Rezny (@quicksparrows)